Mini-CAM

High Pair Count Protection & Distribution 

The Mini-CAM is a high density, single-sided, low profile frame developed to accommodate all types of switching systems for medium to large telecom sites. Its versatility allows use for Special Service circuits, Tie Cables, Trunks or as an Intermediate Distributing Frame (IDF). It is configurable for 400 to over 15,000 pairs. Connectors offer a choice of bifurcated IDCs (Insulation Displacement Clips), bifurcated wire wrap terminals, or 66-clip termination. Special test and communications panels are available including: Test Panel, Combination AC Outlet/Protector Module Tester Panel, and Communications Panel.

Features:

• High density.

• Single-sided administration. and installation.

• Wall or floor mountable.

• Snap-in blocks.

• Spacious wiring troughs.

• Low 84" working height.

• Cable from above, below or both.

• Choice of termination methods.

• Choice of one or five pin connectors.

• Factory tested pre-wired connector blocks

• Array of testing devices available.

• Customized bay arrangements.

• Connectorized versions available.

Compatible Blocks:

Connector Block Assemblies (for single pin modules) - Stubbed (22/24 AWG)*

 Connector Block Assemblies (for male/five pin modules) - Stubbed (22/24 AWG)*

* Indication of length, gauge, and direction of stub cable is required when ordering.